Cutting fiberglass part with a Dremel

[bluntman]

I\'ve never attempted cutting fiberglass so any help would be appreciated. I was just thinking of using the standard cut off wheel at a high to medium speed. What kind of results can I expect? Are there any precautions that I should take before I start?

TIA

[TheProfessor]

Wear goggles ;)

[chimp]

what are you cutting...i\'ve done some work in the past that could help with your job if i knew what you had to cut up

[Domokun]

Wear a N95 mask also. Glass fibers left in your lungs will give you cancer. ;)

[eguiyab]

wear long sleeves... or you can be itching too...

[bluntman]

OK, the cutting is complete. Now, is there anything I have to do to the exposed cut ends? What will happen if I don\'t treat the cut end?