How to remove inner door panel???

[tony_mz3]

This is not the door panel you removed when you install/replace speakers. this is the inner panel where the speakers mounted on.

There are bolts around this inner panel. I removed them all and still can't take it out.

I try to apply dynamat to the inside metal surface. Couldn't find it in the how-to section. Guess I am the only one here who think about doing this?

[blue3]

use some elbow grease , mabey there is some sort of silicone holding it down

[Cardinal Fang]

Here's a great walk through from another board.

http://www.cardomain.com/ride/495957/3

[tony_mz3]

Here's a great walk through from another board.

http://www.cardomain.com/ride/495957/3

:chuckle
Sorry! you probably didn't read my original post well.

You remove one panel to expose the speaker (this is the link you provided and this is NOT what I am looking for).
You then need to remove the inner panel where the speaker is mounted to get to the bare metal (this is what I am looking for :bana2).

I finally figure it out that removing bolts around the inner panel is not enough. There are 2 bolts to hold glass window covered by small plastic cap. I need to lower window and then remove 2 bolts.

[Cardinal Fang]

*File this under Fang wasting another person's time*

[tony_mz3]

:chuckle liar has it all. Remember to do your homework next time then don't need to apologize.

[MPS]

you dont need to do all that
just dyno the spot @ behind the speaker thats all you need