PDA

View Full Version : Looking for part numbers



ptfire
10-31-2007, 10:42 PM
When the dealer fixed the engine mount they had to cut two clips that secure a part of the wiring harness to the battery box. When I opened the hood, before I left the dealer, I noticed it and they said they would order the two clips for me. Well the clips they provided me with are not the correct ones. They are too small and will not stay fastened in the holes in the battery box. I hope one of you will be able to provide me ( hence the dealership) with the correct part numbers.
I am including a couple of pictures to help.
Thanks

http://i75.photobucket.com/albums/i308/ptfire/Mazda.jpg
http://i75.photobucket.com/albums/i308/ptfire/100_1037.jpg
I am not having the best of luck with Oakville Mazda.

royroy
10-31-2007, 10:49 PM
try asking joe...
or go bak to the dealer n tell them is too small =/

ptfire
10-31-2007, 10:54 PM
I'm getting tired of going back to the dealer and also calling them. It's not a good thing when the service manager knows your voice over the phone after owning the car for such a short period.
I did call them to tell that the parts were incorrect and they just don't seem to know how and why. There are far more helpful people on this forum than some service managers.

royroy
10-31-2007, 10:57 PM
well.. u have the right to get that part replaced.. n is their fault.. so they should replace it withoug u paying..

ptfire
10-31-2007, 11:06 PM
I'm won't be paying, trust me. I'm just hoping someone here can get the part numbers for me. The dealer should have told me before returning my car that two clips needed to be replaced and they are on order. If I didn't open the hood and notice, nothing would have been said.
Some "mechanics" work better with a cleaver and a sledge hammer. The funny part of it all is that all the guys in the back were admiring my car and coming up to me and saying how nice the car is. I left there with a scratch and 2 missing clips. Could you imagine if my car was a POS and they really didn't care?

FLIPDADY
11-01-2007, 09:54 AM
The reason why they can't get you the right clips is that the clips cannot be ordered separetly.

I'll see if I have a harness laying around here with the clips on it.

ZoomZoom09
11-10-2008, 08:16 PM
Come by Scarboro, I have some aftermarket clips that are like a clip/zip tie, might work.

Noisy Crow
11-10-2008, 08:27 PM
I am not having the best of luck with Oakville Mazda.

Oakville Mazda service manager and general manager contact info can be found here:

http://www.torontomazda3.ca/forum/showthread.php?t=27967

Have you tried that yet?