MS3 Turbo Manifold? Need more HP.

[REZXPERT]

Can't remember if i put this one out there before but just need some advice on a possible s/s turbo manifold install. Some of the MS3 owner reviews on the American forums sound solid.. wicked spool times, "dyno showed gains of 28HP and 35TQ ...." I might do this at the same time i pick up the Cobb AP and probably ditch my hybrid BOV if the AP doesn't solve the backfiring.

Feedback appreciated as always. Thanks.

[MPS]

28 HP if ur car is stock

[REZXPERT]

not according to buddy... w/ mods. not sure if you can access the link but here it is..

http://www.mazdas247.com/forum/showthread.php?t=123688952

[MPS]

that MBC has alot to do with it

MODS.....Mazdaspeed CAI, Turbosmart MBC @18psi, MAP clamp, Black Forge recirc valve, TRZ delrin motor mount, PG turbo manifold, PG 3" test pipe, Prosport boost gauge on the pillar, clear/black LED side markers, Redline MT90

[REZXPERT]

hey man, my bad, i read into it (under a different thread written by the manifold installer) - buddy had a CAI installed at dyno... other than that, stock.

here it is: http://www.mazdas247.com/forum/showthread.php?t=123688802

[MPS]

well if he had same mods like you gains will be 7 hp

[Unoriginalusername]

well if he had same mods like you gains will be 7 hp

x2... after going with the CPE DP you don't stand to gain an additional 10, 20 or no wear near 30hp with this mod. and despite its warranty i'd be worried about cracks down the road especially with our temp swings.

i'd wait for additional dyons and long term tests before entertaing that mod

[MPS]

lol James ur sig

[Unoriginalusername]

lol James ur sig

it is getting to be a busy place :chuckle :gone