How to remove Lamin-X

[MAZDA Kitten]

Well the burn marks are getting to me and I want these things off my fog lights. I tried peeling this stuff off but its not moving. I have a fresh sheet waiting to go on but this one aint comin off. Waaaaaaa :(

[yearoftherat]

Try using a heat gun then use an adhesive remover.

[Cardinal Fang]

Goo Gone?
Varsol?

[aris]

Try using a heat gun then use an adhesive remover.

+1

[Soyabean]

+1 for the heat gun. But how will you get googone underneath? The sedan fogs dont have much room to work around with.

May i suggest you pick it the edge until one part lifts up and slowly pick at it while heating it up?

[MAZDA Kitten]

That was my concern. There is zero room to get in there but I will try the heat gun method!
Thanks !!!!!!!!

[mleblond]

heat gun, peel it slowly in one motion and the glue wont be all over your fogs. Use googone to clean it out after.