How To Install Fog Lights With Switch

[mazdaskit]

Just wonder if any one knows how to install fog lights with a switch i hav the plugs at the bumper but dont know how to hook them up any one have any suggestions thanks

[-RJ3-]

Unfortunately I cannot help you with the switch, but I had the same predicament.

I decided to get a mazda stalk fog switch handle, and use those plugs you saw at the front of the bumper and attached it to the fogs.

Those wires you plugged in are for the stock fog switch stalk. (the handle you pull to signal, and turn on your lights)

Its cleaner and all you need to do is remove 4 screws from current stalk and replace it with the new.

Check the sponsors, who can help you with the switch.

Good luck.

[mit-gee-mui]

I think this is what you are looking for. However, I don't see any pictures. Do you?
http://www.torontomazda3.ca/forum/showpost.php?p=273221&postcount=2

Not sure if post 3 helps http://www.torontomazda3.ca/forum/showthread.php?t=10101&highlight=fog%2A+switch%2A+instal%2A

Also post 14 http://www.torontomazda3.ca/forum/showthread.php?t=20742&highlight=fog%2A+switch%2A+instal%2A



If I'm barking up the wrong tree, I apologize and I'm sure someone else will point you in the right direction.:)

[towelsnap]

Post #61.

http://www.torontomazda3.ca/forum/showthread.php?t=36126&page=3

Pm Gizzmo_jr he did my install for the how-to

[zoom4106]

hope this one help.... LINK (http://mazda3revolution.com/forums/2010-mazda-3-how-guides/2004-2010-3i-fog-light-installation-guide-pics.html)