Where to port and polish?

[Fobio]

Any recommendations to port and polish an intake in Toronto and surrounding area?

[starscream]

If you have access to a air compressor, buy yourself a die grinder and some bits and you can do it yourself just take it slow. I can show ya, if you need to I lost my last set of porting bits when I fixxed my garage or I would tell ya to come to my place and do it. You might not beable to do it as good as a pro, but you can do enough to balance out the runners (if thats whats youre aiming for).

But heres a few people I have known to do port and polish work:

http://www.gordbushperformance.com
http://www.cylinderheadtech.com/

Those are the only places that I know that do reputable work. MOST performance places will also do it, but they dont specifically specialize in it and hence my cost more, or endup with a job that you could endup doing yourself for less then 1/4 of the cost. Gord Bush I have heard of numerous times and he seems to stand behind his work. Both are in Toronto-ish area.