PDA

View Full Version : X-Pel film for fog lights



PearlM3
04-13-2010, 05:53 PM
I've got the x-pel film tints for my fog lights, and went to install, and it would seem as though I need to take the bumper off to properly fit the tints. Does anyone know a better way to do this.lol. I'm not overly inclined to take my bumper off just to put on some fog tints. :bang

Gizzmo_jr
04-13-2010, 06:36 PM
pm mleblond

Soyabean
04-13-2010, 07:02 PM
Take a piece of paper, put it over the fog and trace the shape. Then cut it out and use it as a stencil for the x-pel. This stuff (if it is the same as lamin-x) is very workable and can be pulled off and put on again as long as you have it moist. Use a blow dryer to soften the x-pel too so u can stretch it if you need to