Air Intake Selection Button does not work

[VaNc3y]

My air intake selection button is stuck on taking air from outside.. when i push the button it does not switch over to air that just circulates inside the car.:loco this is very annoying as i drive down a dirt road to work that's under construction and i just love breathing in all that dust :chuckle

any ideas how to fix this? i'm no electrician nor vent specialist.. if it's not gonna work i'd rather it be stuck on air circulating inside the car regardless of what the manual says.. :bang

halp!

[3GFX]

What setting do you have your vents on? I think it only works if you have it set to feet, face feet, or face.

[eqlso]

^ +1. Doesn't change when you have the setting on the windshield.

[Noisy Crow]

^ +2 ... to prevent the windshield from fogging up due to recirculated moisture.......

[VaNc3y]

oh ok.. so all i have to do is change setting of where the air is coming out in the car to close off the outside air.. ?

i'm not even sure what it's set on right now.. i think feet and windshield.. and i had the motor off but heat was still coming out the vents blowing in my face mixed with dust.. so i knew engine heat was coming in since i didn't even have the blower on

[VaNc3y]

ps. 3dfx your car is BEAUTIFUL

[VaNc3y]

edit* 3GFX

couldn't find an edit button on my message?? that disabled on this site?

[5_Alive]

No its not disabled. I believe at the 50 post mark you will be able to edit your posts.

Turn the knob from hot to cold to start, and then switch the recirculate switch to fresh vent..
If the car is having issues, LMK.. I'll meet up with you this weekend and check it over for you..