Replacing read-side reflector

[Jerm]

Hello, all.

Had a small incident this past weekend (due to snow) that resulted in a shattered reflector; the one behind the rear wheel well, not on the bumper.

I've got the part and I've done some research. From what I've read, it seems I don't need to remove the bumper to get the remains of the old out and the new one in, but I haven't been able to find instructions for this.

Any thoughts? Is there a write up someone could point me towards?

Thanks!

[cwp_sedan]

Correct you don't need to remove the bumper. It just pops in. If you lay on the ground you can reach your arm up and grab the clips on the inside.

The rear reflectors are a different story though.

[Jerm]

That's all there is? Great, thank you. Now, to find someplace without snow to do it on.

Thanks!

[cwp_sedan]

Yep, it's quite simple to remove them. I would suggest doing it where it's a little warmer though because you will run the risk of breaking off the tabs because of the cold plastic. Just a thought.

[Rapster]

Follow this link for a guide on how to remove any of the rear/side reflectors.

http://www.torontomazda3.ca/forum/showthread.php?24774-How-to-remove-your-rear-bumper-to-install-smoked-reflectors

Also, shouldn't have a problem with installing the new one in this weather, just keep the new one inside to keep it warm and only bring it out when you're ready to put it in. The plastic shouldn't get cold enough in that time to break any of the tabs.