View Full Version : Lowering Probleme.. :(
Thrix
03-28-2011, 12:55 PM
Few weeks ago I lowered my car.. By my mazda Dealership.
But , my front look jacked up ..
My front doesnt look lowered at all : /
http://i874.photobucket.com/albums/ab303/Eric_Collon/WP_000091.jpg
I dont know what to do
They are H&R
Thrizzl3
03-28-2011, 12:57 PM
when did you put them on?
Iceman_F1
03-28-2011, 12:58 PM
Also, based on your signature, you list "H&R springs [ 1.6 F / 1.9 R]"...so if that's true, the yes, the fronts won't be as low as the rear...
EDIT: Went on their site, that is what they list. They also have a note of "Lowering varies by engine size and model "
Either they haven't fully settled and wait a bit longer. Or they have fully settled and that's just what they are. Either way, they both look about even from what I can tell in that picture.
Thrix
03-28-2011, 01:03 PM
On our mazda 3 , the rear is higher then the front. By putting a 1.6 drop in the front and 1.9 in the rear , the car should be equal. But mine , doesnt look equal at all
chan7
03-28-2011, 01:34 PM
hey thrix, depending on when you had it done, I would give it about 2-3 weeks for it to settle in. I'm on prokits and the drop wasn't as noticeable until the 3rd week, which made it a bit lower than I expected.
Also, do an alignment after about the 2-3 weeks period as well.
Thrix
03-28-2011, 01:40 PM
Aright thanks :)
Im going for my wheels tomorrow morning !
I'll do an alignment when I'll put my rear camber kit !
Powered by vBulletin® Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.