Need to run 2 small wires to my engine bay. Where is a easy spot to sneak them in?

[gskills]

Helllo

I have a hatchback and i need to run 2 wires into my engine bay.
Where is a good spot to run them in ? I dont want to drill anything

Thanks

[cwp_sedan]

If you have an auto trans you can drill a small hole in the plastic clutch cover plate. That is the best/easiest way to go through. If you have a manual trans try going through the grommet behind the glove box.

[Egierda]

Use the main grommet in the firewall that the ECU harness runs through.

[gskills]

i have a auto
im runing two wires from my compass mirror for a temp sensor ill go looking for the clutch hole cover if not then maybe the main harness


thanks

[bluemazda3]

Use the main grommet in the firewall that the ECU harness runs through.


+1

[Default User]

If you have an auto trans you can drill a small hole in the plastic clutch cover plate. That is the best/easiest way to go through. If you have a manual trans try going through the grommet behind the glove box.

+1

[KING1307]

id suggest that you use the glove box technique, much much easier. couple of screws and a little fooling around. shouldnt take all that long.