PDA

View Full Version : Need Rear Endlinks


JayJay18
06-28-2011, 03:29 PM
Does anyone know of any good adjustable endlinks?
My OEM ones are starting to come apart and its time for new ones?
shu5892001
06-28-2011, 03:37 PM
Tri-point ones?
rzapata
06-28-2011, 04:15 PM
Does anyone know of any good adjustable endlinks?
My OEM ones are starting to come apart and its time for new ones?

How do you know if they're starting to fall apart? Pictures maybe? I just want to know how that would look... :)
MajesticBlueNTO
06-28-2011, 04:22 PM
if you're not going to 1) track your car, or 2) use aftermarket adjustable end links to dial out pre-load, or 3) run a larger rear bar..then just go with OEM.

if you do decide on Tri-Point rear endlinks, note that it doesn't have rubber bushings so you WILL hear clunking in the rear at times.
JayJay18
06-28-2011, 09:17 PM
if you're not going to 1) track your car, or 2) use aftermarket adjustable end links to dial out pre-load, or 3) run a larger rear bar..then just go with OEM.

if you do decide on Tri-Point rear endlinks, note that it doesn't have rubber bushings so you WILL hear clunking in the rear at times.

I forgot to mention I have hotchkis rear sway bar
Darkice
06-29-2011, 12:56 PM
my driver side one is making a clanking noise , so i bought a pair of oem endlinks off ebay 40 plus free shipping
Shawn
07-01-2011, 10:00 PM
Is OEM good enough for Rear Sway bar (HotchKiss)?

Anybody try these
http://www.powergridinc.com/swaybar.asp
Or These
http://www.whiteline.com.au/do_segue.php?make=Mazda&model=Mazda+3&vehicle=BK+%28AXELA%29+1%2F04-9%2F09
Shawn
07-02-2011, 06:38 PM
Anybody put MazdaSpeed Rear links on their Mazda3 ?
Thrizzl3
07-03-2011, 02:56 AM
wait jason..u need rears? i thought the noise was coming from the front...?
JayJay18
07-03-2011, 10:35 AM
wait jason..u need rears? i thought the noise was coming from the front...?

my rears r fcked, the passenger rear it starting to come apart
Shawn
07-05-2011, 10:50 PM
You can us OEM Mazdaspeed3 links. They will fit the HotchKis, but measure the hole in your bar to make sure.
I just bought a set from MOT. They are 12M1.25 stud (beefer than MZ3) for the bar and 10M.1.5 for the control arm connection. Mazda ones do not come with the Nuts. :loco . So you have to order separately.
Or you can order Moog ones for Mazdaspeed3. They are about 10$ cheaper than Mazda and the have a bronze ball cup and have grease fittings. PN# K750069

I hope I don't regret getting the Mazda ones.