DRL / High Beam not working.. Help please! (2010 Mazda 3 Sport)

[altezza]

Hi,

Just hoping to see if any fellow members here can shed some ligh tot my Daytime Running Light / High beam issue ony m 2010 Mazda 3 Sport. I had the Nokya (9005) hyper yellow bulbs installed and ran for 3 years with no issues. I noticed last Friday that my DRL did not turn on, so I replaced my bulbs with the Eurolite from nextmod. Same issue, the DRL did not turn on and only 1 side turned out when I used high beam.

I searched the owner's manual and took out the DRL relay (as per picture from another member) and now none of the high beam works. I made an appointment to check with Jimmy this Thurday, but if anyone can provide some input would be greatly appreciated!! Thank you guys!!

http://i11.photobucket.com/albums/a190/bmw_racing/IMG-20110223-00009.jpg

[leecheefoto]

Change the fuse you blew it. It's on the engine side. Number 33-38 two of them. It takes a 15amp fuse. Check it first!

[altezza]

Thanks for the input! I will check the fuse after I get off work. Just want to verify, did you mean Fuse 32 and 33? Or check all the fuse from 32 to 38? Sorry for the confusion.

32 H/L LO RH 15 A Headlight low beam (RH)
33 H/L LO LH 15 A Headlight low beam (LH)
34 ILLUM 7.5 A Dashboard illumination
35 TAIL 15 A Tail lamp
36 ENG INJ 15 A Engine control system
37 ENG BAR 15 A PCM
38 ENG BAR 2 20 A PCM

[leecheefoto]

Actually its fuse #5 , 20A . #32/33 is the low beams but if your low beams work fine then nevermind!

[altezza]

I pulled out fuse #5 and it shows that it's normal as per example below. All my other lights work (low beam, signals, side marker, etc). Do you have other ideas that I can look into?

http://img4.imageshack.us/img4/6058/38996587.jpg

[altezza]

I pulled out fuse #5 (the green 20 fuse) and it was normal as per the diagram I tried posting earlier (pending approval from the moderator). Any other suggestions? Thanks for the help guys!

[leecheefoto]

use tinypic or photobucket to host your pictures. The fuse wasn't blown?

[altezza]

Sorry, I tried Tinypic, and it still had a pending approval by moderator message. The fuse was not blow as the "U" was perfectly normal, not broken. I PM'ed you instead.