PDA

View Full Version : installed prokit w/ koni orange - rear camber question -



roachkillah
06-05-2013, 04:55 PM
Hello,

Tried searching, but couldn't find an answer.
Installed prokit/koni orange/progress rear swaybar and rear camber arms.
Back from the alignment shop and this is what my print out has.

LF RF
Camber -1.32 Camber -1.37

LR RR
Camber -2.32 Camber -2.39

Although its all in the green, i can visually see there is negative camber on the rear tires.
I'm going back to get the rears set to -1.50m but i've read by doing so, i risk the handling characteristics.

Any suggestions?

Booter22
06-05-2013, 05:07 PM
.

Cab0oze
06-05-2013, 05:50 PM
As long as your toe is fine and you rotate your tires around every oil change you should be fine. As I have recently learned the hard way, toe kills tires, not mild camber.

Another helpful tip I got from msf - if you want even wear, drive it like you stole it. That will make sure the tires get worn all around ;)

schmat66
06-05-2013, 06:05 PM
my bets are you arnt tracking, so dont worry

roachkillah
06-05-2013, 06:25 PM
<schmat66 > you're right im not tracking at all
matter of fact i just hated the way the car looked before, to high.
would it be ok if i get my rears set to -1.5° of camber without affecting my daily driver?

thanks

schmat66
06-05-2013, 07:08 PM
<schmat66 > you're right im not tracking at all
matter of fact i just hated the way the car looked before, to high.
would it be ok if i get my rears set to -1.5° of camber without affecting my daily driver?

thanks

realistically anything you set it too wont affect your driving, it will only affect your tire wear. 1.5 will be good

roachkillah
06-05-2013, 08:10 PM
<schmat66 >
thanks man,
going back to the shop Sunday to get her done.