View Full Version : Noise after installing Prokit.
Agila
07-04-2013, 10:20 PM
Hello guys,
About a month ago, Eibach prokit was installed on to my car. And after like a few weeks, I am starting to hear some rubbing noise on the front passsenger side, this only happens when I turn to the right. What could it be?
Could it be some bushings? or something loose? or just something was not installed back properly? The sounds is getting to my nerves. I also have RB RSB installed, I doubt it that this would cause the sound.
Any ideas/helps/suggestions, will be much appreciated!
Thanks alot for the inputs.
-Mark
JonsMazda
07-04-2013, 10:33 PM
Not sure this helps but did you bring your car to get it aligned after the install?
Shinglez
07-05-2013, 12:01 PM
Could be your bushings. I have a similar noise but I have coilovers and it happens at slow speeds
Agila
07-05-2013, 01:53 PM
Not sure this helps but did you bring your car to get it aligned after the install?
Yes, I got it alligned and everything is good. Except for just that noise.
Agila
07-05-2013, 01:54 PM
Could be your bushings. I have a similar noise but I have coilovers and it happens at slow speeds
Yes could be bushing but which one? Lol lots of bushings down there.
Noisy Crow
07-05-2013, 02:07 PM
What rims, & tires are you running?
Agila
07-06-2013, 12:30 AM
What rims, & tires are you running?
Well, I am running 17" Fast Hayaku 42 offset wrap with 225-45 Ventus V12.
But still, with my stock rims before, still I can hear a sound.
709-mz3
07-06-2013, 09:23 PM
Did you try to bend the dust guard back? I got an eibach install and had the same problem. Used a screwdriver to push the dust guard, behind the rotor, back and rubbing noise was solved. Sometimes, the guard can get bent in when its up on lift.
Hope this helps,
Agila
07-07-2013, 05:41 PM
Did you try to bend the dust guard back? I got an eibach install and had the same problem. Used a screwdriver to push the dust guard, behind the rotor, back and rubbing noise was solved. Sometimes, the guard can get bent in when its up on lift.
Hope this helps,
I'll try to check that out when the weather clears out. Thanks for the info!
SomeGuy
07-07-2013, 11:08 PM
The splash shield turns with the wheel (left right, not rotating)...I doubt it would be making the noise if he only hears it when he turns.
I would guess tire rubbing against wheel liner first. Park the vehicle with the wheel turned hard over and feel around to see what the clearances are.
Agila
08-03-2013, 12:33 AM
Damn it, no luck finding the issues.! any more suggestions?
thanks alot!
Powered by vBulletin® Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.