Maf Sensor & BOV relocate? Places that do it?

[RetroLite]

Looking to get my Maf Sensor and Bov relocated on my intercooler piping. Anyone know of a shop to do this? I need this done so that I can keep the Bov and not have to recirculate it.

[loki]

APH does aluminum welding

[loki]

Maf sensor on intercooler piping?

[RetroLite]

Yes and bov before the maf sensor

[loki]

Putting the maf sensor on the intercooler piping means you're running a blow through system vs a pull through system

Maybe BlueStreak can shed some further light

[RetroLite]

Yeah blow thru is what I am trying to achieve so that I don't have to recirculate my bov and keep the air in the system the same

[BlueStreak]

Yes. This can be done and works very well.

It's not as 'simple' as putting the MAF sensor on the intercooler piping and calling it a day, however. To start, you will need to enlarge the piping before and after the MAF sensor to 3-4" in diameter for a run of 8" or so in either direction.

[Orangevirus]

Yes. This can be done and works very well.

It's not as 'simple' as putting the MAF sensor on the intercooler piping and calling it a day, however. To start, you will need to enlarge the piping before and after the MAF sensor to 3-4" in diameter for a run of 8" or so in either direction.


true, except with the low boost he is running, I wouldn't go with 3-4 inch MAF housing. 2.75 is fine and won't max out on low boost levels. The best size is to make sure you are using at least 75-80% of the MAF scale

[BlueStreak]

Was there mention of boost levels? I don't see anything.

If you're going through all the work of a blow through setup, I'd at least get a 3".