2.5 with 6spd swap complete in 08 gs sedan but....

[nepal1344]

So my swap was a success but my crank pulleys were not marked I had to mark them myself. Once everything was changed over and i started it up i got a P0016 code "Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)". That being said i suspect i may have been a tooth off on my tdc mark...Is there a way that i can find out which direction my pulley is off by without trial and error?

[TheMAN]

marking does NOT work
you need to buy the special crank stopper bolt that you install at the back of the block, then fit the crank pulley on properly

all of the proper procedures are in the shop manual

[nepal1344]

yeah completed last night all timed and she's purring like a kitten now. A little tuning and she'll be ready to go.