MajesticBlueNTO
12-10-2004, 05:39 PM
in addition to the Speaker Test posted by MazdaTree (http://torontomazda3.com/forum/read.php?TID=1235), there are others:
NOTE: Ignition must be in the ACC or ON position (if the car isn\'t running). In all cases, turn the audio power off or turn the ignition to LOCK to stop the diagnostic assist modes.
LCD Inspection
1. With the audio power on, press the POWER button and the upper SEEK button at the same time for 1 second.
2. The LCD display will go full contrast and you can see that all the characters are working.
Button Inspection
1. With the audio power on, press the POWER button and the CLOCK button at the same time for 1 second.
2. Pressing each button will cause a beep if good. (the buttons are \"inactive\" at this point but they will cause a beep when pressed).
Radio Reception
In addition to hearing or not hearing static, you can visually determine how good your radio reception is for a particular channel.
To determine if there\'s a problem, the following test must be done with a radio station that has good reception. (For $hits and giggles, you can drive around in this mode to see how good/bad your reception is for a particular station.)
1. With the audio power on, press the POWER button and the PRESET 2 at the same time for 1 second.
2. You\'ll see a LEV-X beside your radio station frequency.
if X = 5 to 9 > antenna system is good (good reception :p)
if X = 3 to 4 > change frequency and check again (looks like 93.7 isn\'t that strong ;) )
if X = 0 to 2 > check antenna and base unit (101.1 just isn\'t getting through :( )
NOTE: Ignition must be in the ACC or ON position (if the car isn\'t running). In all cases, turn the audio power off or turn the ignition to LOCK to stop the diagnostic assist modes.
LCD Inspection
1. With the audio power on, press the POWER button and the upper SEEK button at the same time for 1 second.
2. The LCD display will go full contrast and you can see that all the characters are working.
Button Inspection
1. With the audio power on, press the POWER button and the CLOCK button at the same time for 1 second.
2. Pressing each button will cause a beep if good. (the buttons are \"inactive\" at this point but they will cause a beep when pressed).
Radio Reception
In addition to hearing or not hearing static, you can visually determine how good your radio reception is for a particular channel.
To determine if there\'s a problem, the following test must be done with a radio station that has good reception. (For $hits and giggles, you can drive around in this mode to see how good/bad your reception is for a particular station.)
1. With the audio power on, press the POWER button and the PRESET 2 at the same time for 1 second.
2. You\'ll see a LEV-X beside your radio station frequency.
if X = 5 to 9 > antenna system is good (good reception :p)
if X = 3 to 4 > change frequency and check again (looks like 93.7 isn\'t that strong ;) )
if X = 0 to 2 > check antenna and base unit (101.1 just isn\'t getting through :( )