PDA

View Full Version : What are these?!


///M
02-03-2005, 01:05 AM
http://individual.utoronto.ca/cc_706/whatarethese.jpg

Came with my Xtec kit. Does anyone know what these are for? (and how they would go onto the bulbs?). Do they act as spacers eliminating the need for the rubber grommets or bath tub plugs?
al01
02-03-2005, 01:09 AM
Originally posted by autoexe


http://individual.utoronto.ca/cc_706/whatarethese.jpg

Came with my Xtec kit. Does anyone know what these are for? (and how they would go onto the bulbs?). Do they act as spacers eliminating the need for the rubber grommets or bath tub plugs?

what is that lol.. i dont have it in my xtec kit :p :p

btw nice keyboard :)
MajesticBlueNTO
02-03-2005, 11:14 AM
they\'re the H7 spacers similar to the stock one. however, you have to cut off the bottom to slide it through the wires...or cut a section and slide the wires through then push the adapter up to the base of the bulb.

too much work, which is why i used grommets.
chaser
02-04-2005, 12:36 AM
Originally posted by MajesticBlueN
too much work, which is why i used grommets.

same here
Devin98
02-04-2005, 04:30 PM
yeah they are the spacers for the H7\'s on our Mazda\'s however just use to Rubber Gormments so much easier :)
Ex-Rolla
03-15-2005, 10:15 PM
Originally posted by autoexe


http://individual.utoronto.ca/cc_706/whatarethese.jpg

Came with my Xtec kit. Does anyone know what these are for? (and how they would go onto the bulbs?). Do they act as spacers eliminating the need for the rubber grommets or bath tub plugs?

Hey autoexe, did you happen to use the spacers that came with the kit? I had my HID installed at Lockdown, so they modified the spacers to fit, but the bulbls still rattle when going over bumps. Do you have the same problem?

for those who have used rubber grommets, do your lights rattle?

Thanks

Ex
///M
03-15-2005, 11:13 PM
My HIDs were also installed at Lockdown using the spacers (modfied), but they don\'t rattle. It\'s a very tight fit.
Ex-Rolla
03-16-2005, 12:12 AM
Hmmm.. k thanks, I\'ll give them a call to see if they can fix it.

Ex
bascind
12-07-2007, 02:40 PM
they\'re the H7 spacers similar to the stock one. however, you have to cut off the bottom to slide it through the wires...or cut a section and slide the wires through then push the adapter up to the base of the bulb.

too much work, which is why i used grommets.

What kind of grommets and how many did you use? I'm trying to find ways around this bulb adapter issue.
bascind
12-07-2007, 02:57 PM
nevermind... found the answer from another thread