Hey guys,

I went down to do a test fit of my Nextmod 07+ GX/GS Lip, just wanted to get an understanding of where to place the screws and where I would need tape.

After test fitting I had a few questions:

1. Where are people applying 3M Molding tape? Are you applying in long strips along the whole lip interior?

2. Where are you placing your screws? There are 8 with the lip.

3. Does the bottom corner of the lip (which fits into wheel well) need to match up exactly with the wheel well?

here is a picture of what I am refering to


what you see is the lip mating with the wheel well, but you can seethe lip edge is considerably lower than the end of the wheel well, mind you the lip fitment is fine even when this happens. I am not sure if I need to push the lip end right up into wheel well.

4. 2 existing screws in the wheel well that hold the spalsh guard, do you remove them and then place the lip on then re screw those through the lip back into the bumper?

oh and yes, it is a dirty picture I know, it had just rained and I was dying to test fit


Thanks