Sway Bar Spacers MS to MZ swap

[MDMaz3]

I've reviewed a number of posts that talk about using spacers to provide a better fitment of the mazdaspeed rear bar to the mazda 3 endlinks.

Does anyone have any pics, or something general off the web I can look at so I have some idea of what I need to buy to ensure a good fitment? It'd be greatly appreciated.

If you could advise the size, that'd be a bonus as well.

Thanks in advance for your help guys!

[stevenma188]

MS3 = 12mm endlink, MZ3 = 10mm endlink

http://www.mazda3forums.com/showthread.php?t=373384

Or I used a piece of clear hose.

[silverstarmazda]

i used a mini metal tube at home depot

[MDMaz3]

Thanks so much guys for the help. I've gone to the guys in our workshop in our building and they're going to take the bar and size it for a 12 mm fitting with a 2 mm thickness copper or stainless tube. They also added they'd trim it close to the bar as possible so the bolt goes through and doesn't have any overlap past the bar.

I appreciate you're input tremendously. Hopefully it holds out, if not will look to obtaining MSP3 swaybar links.

[MDMaz3]

Thanks so much guys for the help. I've gone to the guys in our workshop in our building and they're going to take the bar and size it for a 12 mm fitting with a 2 mm thickness copper or stainless tube. They also added they'd trim it close to the bar as possible so the bolt goes through and doesn't have any overlap past the bar.

I appreciate you're input tremendously. Hopefully it holds out, if not will look to obtaining MSP3 swaybar links.

What would I be if I didn't show pics to follow up on my gratitude. I hope the pic pans out.

[MDMaz3]

Thanks so much guys for the help. I've gone to the guys in our workshop in our building and they're going to take the bar and size it for a 12 mm fitting with a 2 mm thickness copper or stainless tube. They also added they'd trim it close to the bar as possible so the bolt goes through and doesn't have any overlap past the bar.

I appreciate you're input tremendously. Hopefully it holds out, if not will look to obtaining MSP3 swaybar links.

[MDMaz3]

http://[img=http://imageshack.us/scaled/thumb/233/sway2.jpg]

Pic of final sleeve installed for 10 mm MZ3 endlinks to follow up. Used some copper pipe.